1: How durable are StrawCore buildings compared to standard US
construction?
We are designing StrawCore buildings to last hundreds of years
with a minimal amount of maintaince. While it is possible for stud
and drywall buildings to have similar life spans, the maintenance
costs eventually become unmanageable. With conventional
construction many aspects of the building need to be replaced on a
regular basis. Roofs, gutters, siding, paint, even insulation and
drywall eventually need to be replaced. Rodents make their way
into wall cavities, termites devour the structure, and wooden
buildings are a fire hazard. The fire insurance costs for a period
of several hundred years alone render a typical US home
unsustainable.
With StrawCore construction, there are no wall cavities,
buildings will not burn, there is no wood for termites, and
virtually everything that would normally need to be replaced is
integrated into the structure. Conventional houses are composed of
thousands of pieces that are susceptible to degradation over time,
while StrawCore houses, on the other hand, would be composed of a
few dozen monolithic components.

2: Don't plant fibers like straw deteriorate?

3: But doesn't straw and plant fiber burn?
Yes straw burns, but StrawCore panels do not. There two reasons
why they will not burn;
 |
The plasters that are used throughout the panels have a high
mineral content which render them nonflammable. |
 |
Unlike conventional construction there are no wall cavities,
which would otherwise facilitate combustion inside the wall. |
As part of a recent contract with the EPA, we were required to
perform a burn test. To comply with the test we built a kiln with
one wall composed of StrawCore. The kiln needed to be kept above
1,000°F for 2 hrs with the temperature to peak at 2,000°F. In
order to pass the test, the temperature of the outside surface of
our sample could rise no more than 250 F. We let the test run for
3 hours, and at the end of that time the temperature on the
outside of our sample rose 5.4°F.

4: If the plaster on the outside of the building is some sort
of adobe, won't that erode over time?
In order to formulate the plasters and the matrix material (the
internal mortar) we drew upon a wide range of sources, from
ancient adobe techniques to modern cement, fiber, and resin
technologies. Various formulations are intended for different
surfaces to provide the required protection. The plaster for the
roof is waterproof and UV resistant. The plaster for the exterior
walls is weatherproof and breathable, while the plaster intended
for interior walls is slightly water soluble so a fractional
amount can be washed off periodically to expose a fresh plaster
surface.

5: What kinds of fasteners are used with this kind of
construction?
Bamboo pins are used to help bind the layers together, and the
panels themselves are joined together using hardware cloth
imbedded in the plaster. Screws work well to hold cabinets and
other internal fixtures.

6: Have any houses been built yet?
We have only built wall sections and other components for
engineering tests. We are planning to build the first houses this
summer.

7: Do other fibers work as well as wheat straw?
Almost every plant fiber that we have tested works better than
wheat straw. The only reason that we are still using wheat at all
is because it is so abundant. Some of the other plants that we
have tested are many times stronger than wheat.

8: Would a StrawCore building be as strong as a wood framed
structure?
A StrawCore structure would be substantially stronger than a
typical wood framed structure because of the nature of composite
construction. With composite systems, loads are distributed across
the entire panel rather than the point loading that occurs with
stud framing. Due to the extreme low cost of this type of
construction, it’s entirely feasible to add additional layers to
obtain desired structural strength and/or thermal insulation.

9: What is the R value of StrawCore?
The only fiber that we have tested so far is wheat straw, and
the R value for that equals about 1.5 per inch. We are hoping for
higher numbers from some other fibers. As insulation goes, 1.5 is
not spectacular and that is why the walls are as thick as they
are, but there is another factor working in our favor, and that is
thermal mass. The high mineral content of the plaster and matrix
material result in a high thermal mass quotient. In hot climates
the thermal mass quotient of StrawCore can more than double the
effective R value.

10: How expensive would a StrawCore house be?
We expect StrawCore houses will be built at a fraction of the
cost of conventional construction. The bulk of the raw materials,
(straw and soil) are virtually free, construction does not require
skilled labor, and we are working hard to keep processing costs to
a minimum.
|